Redwing Milling Dimensions

[tehachapifan]

Might someone be able to check the dimensions of Redwing Milling, if they have it? I'm first looking for just the length and width of just the main building (excluding any docks, overhangs and that rear furnace/chimney thing), then the maximum length and width dimensions with all those things included.

Thanks!!

[Jeff AKA St0rm]

Here they are

[tehachapifan]

Thanks! Those do help, but I could also really use the width of just the main building excluding the boiler room, docks, etc.

[GaryHinshaw]

Assuming the "main building" is the largest rectangle in the diagram, we can measure the photo and scale the given dimensions.  I get 5-7/8" x 3-1/8", which is probably good to +/- 1/8".  Hopefully that's good enough for planning...

[tehachapifan]

Thanks, Gary! It's going in a very tight space, so I was hoping to get the exact dimensions. That said, your estimates are probably pretty close.

Thanks!

[Frisco Larry]

The main building is 41.5 N Scale feet wide, but there is a cornice that is 43.5 N Scale feet. The length is 79.5 feet plus the same 2 feet for the cornice.

[tehachapifan]

OK, great! Thanks!