« previous next »
Pages: 1 [2]   Go Down

Author Topic: Problem with programming a TCS cn decoder on Digitrax  (Read 5851 times)

0 Members and 2 Guests are viewing this topic.

soo

  • Crew
  • *
  • Posts: 637
  • Gender: Male
  • Respect: +107
Re: Problem with programming a TCS cn decoder on Digitrax
« Reply #15 on: September 28, 2013, 01:22:04 AM »
0
Can't program any cv's,,,because I get the NoAk message. Which means Digitrax does not acknowledge the decoder.

  This really really really making me upset.

Wyatt
Logged

mmyers

  • The Pitt
  • Crew
  • *
  • Posts: 1001
  • Respect: +50
Re: Problem with programming a TCS cn decoder on Digitrax
« Reply #16 on: September 28, 2013, 07:49:09 AM »
0
Have you tried other direct mode programming? Just a shot. After reading through your original post my best guess is the decoder is bad. It works on 03 and you can program other decoders? Then the decoder is bad. No short or contact problem because it works on address 03. It also isn't something done on installation because again, it wouldn't work on address 03.

Martin Myers
Logged

sizemore

  • The Pitt
  • Crew
  • *
  • Posts: 2683
  • Respect: +79
Re: Problem with programming a TCS cn decoder on Digitrax
« Reply #17 on: September 29, 2013, 02:26:13 AM »
0
The only other item I'd try is adding a ballast to the rails something as simple as a light bulb spanning both rails.

The S.
Logged

Thompson Sub: Instagram | Youtube | Website

soo

  • Crew
  • *
  • Posts: 637
  • Gender: Male
  • Respect: +107
Re: Problem with programming a TCS cn decoder on Digitrax
« Reply #18 on: September 30, 2013, 01:32:05 PM »
0
Once again guys Thank you for the help.

  I really hope it is a bas decoder,,, because I have plenty of locos that can use the CN type decoder.

  Wyatt
Logged
Pages: 1 [2]   Go Up
« previous next »