Author Topic: what type of glue would be good to use reapplying printed signs onto buildings w (Read 1165 times)

KEWATIN · « **on:** January 21, 2012, 10:19:10 PM »

i have printed &scaled down some signs so i can apply to my town buildings but not sure what glue agent to use, as i don't want bleed thru. any suggestions would be greatly appreciated.
REGARDS&LATER KEWATIN

johnhale · « **Reply #1 on:** January 22, 2012, 12:05:49 AM »

I have been using Matte Mod Podge (the stuff used to make paper mache) to attach printed signs to buildings, I use it both under and over the printed sign.

John

Bremner · « **Reply #2 on:** January 22, 2012, 04:04:02 AM »

if it is paper...Elmers Glue Stick

Ian MacMillan · « **Reply #3 on:** January 22, 2012, 05:40:04 AM »

I've used 3M spray adhesive.

KEWATIN · « **Reply #4 on:** January 22, 2012, 03:13:57 PM »

thanks ever so much, i shall experiment with all 3 and pick the one i am most comfortable with. this is why these forums are so important ,as you can tap into the others whom have paved the way of trial &error.
many thanks regards&later KEWATIN

Author Topic: what type of glue would be good to use reapplying printed signs onto buildings w (Read 1165 times)

KEWATIN

what type of glue would be good to use reapplying printed signs onto buildings w

johnhale

Re: what type of glue would be good to use reapplying printed signs onto buildings w

Bremner

Re: what type of glue would be good to use reapplying printed signs onto buildings w

Ian MacMillan

Re: what type of glue would be good to use reapplying printed signs onto buildings w

KEWATIN

Re: what type of glue would be good to use reapplying printed signs onto buildings w