« previous next »
Pages: 1 ... 3 4 [5]   Go Down

Author Topic: Auto Rack mobile unloading ramp...  (Read 22406 times)

0 Members and 1 Guest are viewing this topic.

TrainCat2

  • Crew
  • *
  • Posts: 1998
  • Gender: Male
  • I'm here to take a beating from RailWire members.
  • Respect: +860
    • TrainCat Model Sales
Re: Auto Rack mobile unloading ramp...
« Reply #60 on: May 05, 2010, 05:26:21 PM »
0
I did not release them yet Mark. I am re-tooling for stainless steel instead of brass. Brass at .005" is not sturdy enough. I am shooting for Aug.
Logged
Regards
boB Knight

I Spell boB Backwards

TiVoPrince

  • Crew
  • *
  • Posts: 5156
  • Respect: +3
    • http://www.technologywrangler.com
Re: Auto Rack mobile unloading ramp...
« Reply #61 on: May 05, 2010, 05:58:54 PM »
0
Looking
at a proto photo.  Are the angled braces supposed to be nearer the end?  Also I'm not seeing the landing pads at the low end?  Not going to keep Mr. Wallet inactive for long in any case...
Logged
Support fine modeling

Glenn Poole

  • Crew
  • *
  • Posts: 146
  • Respect: +1
Re: Auto Rack mobile unloading ramp...
« Reply #62 on: May 06, 2010, 10:15:17 AM »
0
Quote from: bicknell on May 05, 2010, 02:13:42 PM
Makes me wish I'd ordered one of those auto-racks with an end that opened, rather than all closed ones.  You should team up with whoever made them (was it Red Caboose) and sell a package!


M B Kleins still have some available.
Logged
Glenn
Pages: 1 ... 3 4 [5]   Go Up
« previous next »