Help!

[PiperguyUMD]

These where consecutive prints on the photon. I’ve never had anything fail like the hopper. Fresh FEP, and level job before the 3 boiler shells. I’d imagine if it when out of level or exposure issues, I wouldn’t have gotten the full support job. Any advice? TIA!

[Mark W]

Looks like a simple support failure to me, probably when it prints the end sil which is almost parallel with the build plate. 

[garethashenden]

I've had similar issues where a large flat surface won't release from the film. Increasing the exposure time can help, or rotating the model so that the slope sheet isn't parallel with the build plate.

[C855B]

Same here, a large flat surface inadvertently parallel with the FEP. Change the angle and that should fix it.

[PiperguyUMD]

I've had similar issues where a large flat surface won't release from the film. Increasing the exposure time can help, or rotating the model so that the slope sheet isn't parallel with the build plate.

Awesome! I hadn’t thought of that. Thank you!