N Scale Sawmill.....nearing the end.

[Sumner]

The following are the remainder of the interior machinery parts for the sawmill. These items are really small and some detail is there but basically too small to paint or see. For instance the pillow blocks for the rollers and the belts between the rollers print but are very hard to actually see even up close. The printers now are better at detail than what our eyes can see, at least mine.

 

.



It took me a while watching videos to see how they handle slabs that are way too long to transfer over to the edger saw. The slabs move down the rollers towards the timber cutoff saw until the end of the slab is even with the end of the transfer table over to the edger rollers and saw. A chain saw comes up out of a slot and cuts the slab into two pieces. The one piece next to the transfer table is transferred over to the edger by the four chains that you can see above. Then the rollers down towards the timber cutoff saw reverse and bring the other half of the slab back up along side the transfer table. Then the chains move that slab over to the edger rollers and it moves through the edger which cuts it to width.

More info on Railwire here....

https://www.therailwire.net/forum/index.php?topic=58208.msg816358#new

Sumner

[Sumner]

Sawmill Exterior Stairs & Dock Print Files....

You can find the print files for the 'Stairs & Docks’ on thingiverse  ( HERE ).

=========================================

To see/download the print files go to the link above or at the bottom of this page The following images show you the number of the print files and where they are located on the building. The print file names start with these numbers followed by a description of where they are located.



.

 

.



.



.



.


 

Above some of the stairs and docks are shown on the printer’s build plate.

.... to be continued.

=========================================

You can find the print files for the 'Stairs & Docks’ on thingiverse  ( HERE ).

=========================================

A link to this whole build ( ( HERE ) ).

Sumner

[Sumner]

Interior Machinery Print Files...

You can find the print files for the 'Interior Machinery’ on thingiverse ( HERE ).

 =========================================

To see/download the print files go to the link above or at the bottom of this page The following images show you the number of the print files and where they are located in the building. The print file names start with these numbers followed by a description of where they are located.

The print files for the machinery in the north part of the building are ( HERE ).

 

.



.




.



.   



.

 

.



.



.   



.

 

 .... to be continued.

=========================================

You can find the print files for the 'Interior Machinery’ on thingiverse ( HERE ).

 =========================================

A link to this whole build ( HERE ).

Sumner