Amherst Intermountain chatter

[ek2000]

Intermountain is getting ready to ship the first batch of SD40-2s as many may know.

They also had a pre production sample of a SD45 locomotive. This was an older tooling so did not have separately applied grabs etc.

The F units looked great. The DC only were nicely weighted and should be good pullers. The etched metal grills were dislodged in several samples, likely a result of being on shows.

They are still looking for a factory that would produce the cab forward and have not given up on it. Apparently, the factory is jittery about doing a steam locomotive

The Sd45 bi-centennial announced through NSE is also not too far out.

[kiwi_al]

They also had a pre production sample of a SD45 locomotive. This was an older tooling so did not have separately applied grabs etc.



The Sd45 bi-centennial announced through NSE is also not too far out.

I take it that's the SD45-2 and are they molding treads in their walkways?, cause my set of SD45-2s have no walkway treads

[ek2000]

Sorry, did not look closely enough. They said it was the older tooling, so likely not.

[thomasjmdavis]

Did IM ever make locos without separate grabs? I only have cab units (going back to their first issue FTs) and those have separate grabs. Admittedly, I have no IMRC hood units (because they haven't made a 50s era hood unit). Did the early issue SD units have the drop grabs on the ends cast on?

[GM50 4164]

Is there anyway we can get a good photo of the SD45-2 that they are working on?

[kiwi_al]

Did IM ever make locos without separate grabs? I only have cab units (going back to their first issue FTs) and those have separate grabs. Admittedly, I have no IMRC hood units (because they haven't made a 50s era hood unit). Did the early issue SD units have the drop grabs on the ends cast on?

The IM SD45-2 has molded on grabs at least the first run has.

[kiwi_bnsf]

Did IM ever make locos without separate grabs? I only have cab units (going back to their first issue FTs) and those have separate grabs. Admittedly, I have no IMRC hood units (because they haven't made a 50s era hood unit). Did the early issue SD units have the drop grabs on the ends cast on?

Intermountain have released SD40-2W and SD40-2 locos in N scale with separate grabs on the nose and rear of the long hood, but they are at the coarse end of the detail spectrum 

[kiwi_bnsf]

Is there anyway we can get a good photo of the SD45-2 that they are working on?

It is just the next release of their existing SD45-2 model…

http://www.spookshow.net/loco/imsd45-2.html

I'm guessing it will have a new chassis that supports an ESU decoder and speaker (effectively a slightly longer version of their existing SD40-2 chassis).

[dandopinski]

Intermountain have released SD40-2W and SD40-2 locos in N scale with separate grabs on the nose and rear of the long hood, but they are at the coarse end of the detail spectrum   

Not only that but the cab on the SD40-2W is wrong in all dimensions

[CRR Chase]

I take it that's the SD45-2 and are they molding treads in their walkways?, cause my set of SD45-2s have no walkway treads

Kiwi, I hope they are getting ready to re-release these...