Does Anyone Recognize This Connector?

[peteski]

The connector's crimp is inserted into the male housing noted above and that lines up the connection mating between the two. 

Not much use though if you don't know what the connections trace out to though.  Cough, Cough @peteski

Well, I either have to get Russ to send me the light board, or contact Atlas for the schematic.

[tehachapifan]

Next to one of the female connectors on the board there are markings that say HDL1, HDL2, HNL and what looks like U+ (or V+?). These seem like they just have to be for lighting (HDL seems like it must mean headlight, right?) and it appears there are resistors on the board for all 3 contacts. The markings next to the connector on the other end are a little less clear as to what the purpose is (L1 and L2, I think?). I'm probably going to go ahead and purchase the male connector and wires and give it a go!

[DRGW5349]

I was successful in adding a rotary beacon to my SD-9. I used HDL1 and V+ and a 402 SMLED/ Detail Associates 8222 beacon. AUX 5 controls this function, works like a charm.

[tehachapifan]

I was successful in adding a rotary beacon to my SD-9. I used HDL1 and V+ and a 402 SMLED/ Detail Associates 8222 beacon. AUX 5 controls this function, works like a charm.

Excellent! Good to know!

[peteski]

The connector's crimp is inserted into the male housing noted above and that lines up the connection mating between the two. 

Not much use though if you don't know what the connections trace out to though.  Cough, Cough @peteski

I did send out an email to Scott at Atlas on April 23rd (using the address you gave me) asking for board  layout or a diagram of the board and all I heard is crickets. I might try resending, as in the past Atlas was more responsive to my emails.

[DRGW5349]

I did send out an email to Scott at Atlas on April 23rd (using the address you gave me) asking for board  layout or a diagram of the board and all I heard is crickets. I might try resending, as in the past Atlas was more responsive to my emails.

I had also contacted Atlas about the connector and received no reply.

[peteski]

My offer still stands - if someone sends me the PC board, I will figure out and post the pinout of the connectors.

[peteski]

For pertinent info see https://www.therailwire.net/forum/index.php?topic=58111

[tehachapifan]

Awesome!!