Digitrax DCC analog appearing fast clock ideas

[Bill H]

My layout spans four different rooms and I would like to put a Fast Clock, preferably analog appearing in each room, controlled from the dispatchers office. And Digitrax supported suggestions?

Kind regards,
Bill

[John]

Bill -- the cheapest option might be JMRI -- you could run the JMRI webserver and display a fast clock on a cheap tablet ...



JMRI Fast Clocks - LocoNet Capability

A Digitrax LocoNet can contain it's own fast clock, driven by the DCS100, DCS200, or DCS50 command stations. A separate LocoNet fast clock is available from Logic Rail Technologies. JMRI can work with any of these, or with any clock that uses the standard Digitrax method to control fast clocks.

This page discusses how JMRI can either use or control the LocoNet fast clock.
Controlling the LocoNet clock

The "Clock Monitor" tool in the "LocoNet" menu provides a convenient way to:

    Read the current contents of the LocoNet fast clock
    Set the date and time
    Set the rate. Note that you can't explicitly pause a LocoNet clock, but you can stop it by setting the rate to zero.

If you are using a DCS100 or DCS200 command station to create your LocoNet fast clock, you may have noticed that it doesn't keep particularly good time. If you select the "Correct LocoNet Fast Clock Master", JMRI will adjust the rate of the LocoNet clock so that it keeps better time.
Using the LocoNet clock

The recommended settings for running with LocoNet Fast Clock is: set Time Source to Internal Computer Clock, and check both the Synchronize... and Correct... options. However you can try other settings. If you use the internal computer clock as the time source, you will not be able to change the fast clock rate or the fast clock time from a throttle.

You can also have JMRI use the LocoNet clock for it's own, internal timebase. This keeps the clocks that JMRI displays on the screen synchronized with the LocoNet clock, hence the displays on DT400 throttles, etc.

To do this, select the "LocoNet Fast Clock sets Internal Clock" option on the LocoNet clock monitor window. Note that you should do this before opening the clock windows so that when you open the clock windows they connect to the correct timebase.

/>

If you use a Logic Rail Technologies fast clock, it should be set up as a slave clock, not as a master. You may notice that the Logic Rail Technologies fast clock lags behind by one fast clock minute. Be assured that the correct commands are being sent by JMRI. This lag, if present, is just an artifact of the Logic Rail clock's internal programming.


If you like to tinker -- this looks promising

https://github.com/Futski-III/Arduino-Fast-Clock


Also this

https://www.iascaled.com/blog/pausing-time-using-fast-clock-hold-mode/

[bigdawgks]

Another bonus of using JMRI is that you can launch a WiThrottle server and build your own client that connects to it. The protocol is easy to support and once connected to the server it will send the fast clock time which you can display however you like.

[Bill H]

Bill -- the cheapest option might be JMRI -- you could run the JMRI webserver and display a fast clock on a cheap tablet ...

Hi John,
I operate on one layout that has five analog appearing fast clocks controlled I think - by Railroad & Co software. However, I use JMRI Operations Pro. Consequently, I was looking for some sort of analog appearing interface, which I find reflective of the transaction era I model. A possibility might be an analog image on a cheap tablet.

Kind regards,
Bill