« previous next »
Pages: [1]   Go Down

Author Topic: Sound Decoder install into FVM new release of SP GP-60  (Read 777 times)

0 Members and 2 Guests are viewing this topic.

carlso

  • Crew
  • *
  • Posts: 1119
  • Gender: Male
  • Respect: +502
Sound Decoder install into FVM new release of SP GP-60
« on: March 29, 2017, 09:53:27 PM »
0
Has anyone done this sound install? Just curious about the difficulty. I do not have one yet but looking at Spook Show, it looks like the chassis would be easy to shave off a couple of nubs and the light board looks easy to modify and use by cutting some traces. I am thinking about an ESU Loksound Select Micro with a sugar cube speaker and enclosure.

Any thoughts would be appreciated.

Carl
Logged
Carl Sowell
El Paso, Texas

RBrodzinsky

  • Crew
  • *
  • Posts: 1205
  • Gender: Male
  • Respect: +425
Re: Sound Decoder install into FVM new release of SP GP-60
« Reply #1 on: March 29, 2017, 10:04:32 PM »
0
Carl, the PC board has a six pin connector on it, so you can just plug a 6-pin Select Micro in! Only trick is placing the speaker over one end. But, I don't have one to figure out in detail.
Logged
Rick Brodzinsky
Chief Engineer - JACALAR Railroad
Silicon Valley FreeMo-N
Pages: [1]   Go Up
« previous next »