Author Topic: Shapeways introduces ability to specify build orientation (Read 1315 times)

bbussey · « **on:** April 22, 2016, 02:51:46 PM »

Just announced today at noon EDT. Finally, the ability exists for designers to specify build orientation every time the model is printed.

http://www.shapeways.com/blog/archives/24904-set-3d-printing-orientation-making-your-sls-dreams-come-true.html?etId=87232501&utm_source=sw-email-9&utm_medium=email&utm_campaign=20160422-SO-Excellence-#1

UPDATE — After reading the announcement, I'm unsure if this for SWF products only. You'd think they would extend the option to the ProJet product line as well.

wcfn100 · « **Reply #1 on:** April 22, 2016, 02:59:09 PM »

They had hinted to this a while back. Pretty sure it's just the one material.

Jason

Chris333 · « **Reply #2 on:** April 22, 2016, 03:07:39 PM »

I though you guys were able to this for a while now?

Lemosteam · « **Reply #3 on:** April 22, 2016, 05:51:12 PM »

Yep, I read strong and flexible only.

bbussey · « **Reply #4 on:** April 22, 2016, 06:56:24 PM »

Quote from: Chris333 on April 22, 2016, 03:07:39 PM

I though you guys were able to this for a while now?

As the designer you may request it and inform them you are willing to wait until a slot opens on the build tray in order to have the proper orientation. But it is not possible currently to have parts for the consumer built in a specific orientation.

bb

Author Topic: Shapeways introduces ability to specify build orientation (Read 1315 times)

bbussey

Shapeways introduces ability to specify build orientation

wcfn100

Re: Shapeways introduces ability to specify build orientation

Chris333

Re: Shapeways introduces ability to specify build orientation

Lemosteam

Re: Shapeways introduces ability to specify build orientation

bbussey

Re: Shapeways introduces ability to specify build orientation