« previous next »
Pages: [1]   Go Down

Author Topic: H15/16 Male Universal--revisited  (Read 902 times)

0 Members and 2 Guests are viewing this topic.

carmelmodelrr

  • Crew
  • *
  • Posts: 143
  • Gender: Male
  • Respect: +3
H15/16 Male Universal--revisited
« on: September 14, 2013, 03:52:41 PM »
0
I received my replacement male universals today from Atlas and...   Is there a trick to putting them on to the flywheel shaft?  Do they press-fit onto the shaft?  Or just how do these things fit?  Thanks.

Dick Wroblewski
Logged

SD452XR

  • Crew
  • *
  • Posts: 249
  • Respect: +22
Re: H15/16 Male Universal--revisited
« Reply #1 on: September 14, 2013, 05:41:34 PM »
0
I set them on the shaft and use the blunt end of a wood chopstick to press it on.

Steve
Logged

Bob Horn

  • Crew
  • *
  • Posts: 171
  • Gender: Male
  • Respect: +1
Re: H15/16 Male Universal--revisited
« Reply #2 on: September 14, 2013, 06:26:46 PM »
0
Best way is just a little CA on the end of the shaft on the broken U joint. The new part has a larger opening on one side. Bob.
Logged

carmelmodelrr

  • Crew
  • *
  • Posts: 143
  • Gender: Male
  • Respect: +3
Re: H15/16 Male Universal--revisited
« Reply #3 on: September 15, 2013, 05:55:37 PM »
0
Thanks, guys. I finally got them in by white gluing the male universal to the blunt end of a 3/16" drill bit, then pushing them onto the shaft.  The loco is running well again.

Dick Wroblewski
Logged

Bob Horn

  • Crew
  • *
  • Posts: 171
  • Gender: Male
  • Respect: +1
Re: H15/16 Male Universal--revisited
« Reply #4 on: September 15, 2013, 10:12:56 PM »
0
I have 2 628's on my bench right now, CA fixed both of them. Bob
Logged
Pages: [1]   Go Up
« previous next »