« previous next »
Pages: [1]   Go Down

Author Topic: 2-10-2 tender swap  (Read 1011 times)

0 Members and 2 Guests are viewing this topic.

fredmoehrle

  • Crew
  • *
  • Posts: 217
  • Respect: 0
2-10-2 tender swap
« on: February 06, 2013, 12:21:35 PM »
0
I've got a B'mann 2-10-2 that I want to replace the long USRA tender with a medium USRA tender.
Can anyone point me to where this might have been discussed before?
Thanks.
Logged

chessie system fan

  • Crew
  • *
  • Posts: 1158
  • Gender: Male
  • Respect: +659
Re: 2-10-2 tender swap
« Reply #1 on: February 06, 2013, 12:48:42 PM »
0
If you use another Bachmann tender there's not really much to discuss.  They all use the same drawbar connection. (Right? I don't own every single tender type.)
Logged
Aaron Bearden

sizemore

  • The Pitt
  • Crew
  • *
  • Posts: 2683
  • Respect: +79
Re: 2-10-2 tender swap
« Reply #2 on: February 06, 2013, 12:52:31 PM »
0
You'll have to make sure the decoder from the 2-10-2 fits the medium tender, thats about the only issue I can see off the top of my head. I havent had enough of them apart to know the differences between the decoders vs. tenders.

The S.
Logged

Thompson Sub: Instagram | Youtube | Website

fredmoehrle

  • Crew
  • *
  • Posts: 217
  • Respect: 0
Re: 2-10-2 tender swap
« Reply #3 on: February 06, 2013, 04:08:18 PM »
0
Well, for that matter, the decoder could go.
Logged

CodyO

  • Crew
  • *
  • Posts: 848
  • Gender: Male
  • Cody Orr-SPF
  • Respect: +194
Re: 2-10-2 tender swap
« Reply #4 on: February 06, 2013, 06:07:28 PM »
0
They should fit fine just won`t have the pre installed decoder in the tender and will have to install your own in the medium or try and transfer the stock bachmann one

And then when your done with the long tender you can send it to this guy! :D :D
Logged
Modeling the Pennsylvania Middle Division in late 1954
             Nothing Will Stop The US Air Force
Pages: [1]   Go Up
« previous next »