« previous next »
Pages: [1]   Go Down

Author Topic: Shorts from Fox Valley Wheelsets  (Read 1295 times)

0 Members and 1 Guest are viewing this topic.

Bruce Bird

  • Crew
  • *
  • Posts: 187
  • Respect: +3
Shorts from Fox Valley Wheelsets
« on: September 15, 2011, 10:42:33 PM »
0
Has anyone else had issues with Fox Valley wheelsets shorting out Atlas C55 turnout points?  I had it happen a few weeks ago during an op session.  Really messed things up for about an hour.

Bruce
Logged

Sokramiketes

  • Crew
  • *
  • Posts: 5002
  • Better modeling through peer pressure...
  • Respect: +1546
    • Modutrak
Re: Shorts from Fox Valley Wheelsets
« Reply #1 on: September 15, 2011, 10:48:42 PM »
0
What shorted exactly?  The Atlas turnouts are "DCC Friendly" so a metal wheel set shouldn't cause a short at the points ever... The points are the same polarity as the adjacent stock rail.
Logged

Bruce Bird

  • Crew
  • *
  • Posts: 187
  • Respect: +3
Re: Shorts from Fox Valley Wheelsets
« Reply #2 on: September 16, 2011, 10:10:52 PM »
0
Well, that's what I thought too.  The wheel tread is wide enough that it contacted both the stock rail and the open point.  We ran the car through by hand 10-15 times and replicated the layout short every single time.  The turnout acted like a hand-laid or ME turnout, but it is an Atlas C55.  Very weird.

Bruce
Logged
Pages: [1]   Go Up
« previous next »